Menvier Security TS2500 Manuel d'utilisateur télécharger pdf (Page 21)

Operation Unsetting after an Alarm

If an alarm has occurred whilst the system

was set, the display will indicate the cause of

the alarm when you unset the system. Once

the cause of the alarm has been

established the system must be reset, see

"Resetting after an Alarm" on page 20.

1. Enter the protected area via the

designated entry point. The internal

sounder will sound.

2. Proceed directly to the remote keypad

and enter your passcode. The internal

sounder will stop.

3. The display will show the circuit that

caused the alarm.

4. By pressing the B key the display will

alternate between the circuit text, e,g.

Office window and the logged

time/date of the alarm, e.g. 15:00.30

01/01.

5. The system now requires resetting.

If the alarm system is not reset after an

alarm has occurred the internal

sounder will generate a reset warning

chime every minute as a reminder. To

silence this tone simply re-enter your

passcode.

BANNER MESSAGE

15:27 Sun 01 JAN

ALARM 2002

Office window

ALARM 2002

15:00.30 01/01

ENT

???? ? ? ?

ENTRY A.........

Enter Your Code!

Alarm on circuit 2002

(Office window)

to alternate between

circuit text and

time and date

The system now

requires resetting

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Menvier Security TS2500 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Menvier Security TS2500