Menvier Security TS400 Manuel d'instructions télécharger pdf (Page 14)

Connections & Controls (Cont.)

EXT. VOLUME (VR1) - If an extension loudspeaker is connected to the control panel,

the volume of keypad bleeps, chime, entry and exit tones may

be adjusted using this control (clockwise to increase). Alarm

tones are always full volume.

INT. VOLUME (VR2) - This controls the volume of keypad bleeps, chime, entry and exit

tones from the internal loudspeaker (clockwise to increase). The

volume of the speech dialler playback messages are always full

volume.

F/EXIT - This pair of terminals is for connecting to the Final Exit detection

device, normally a set of magnetic contacts on the front door.

The tamper loop should be connected in series with other loops

across the terminals mark AUX TAMPER (see Connection

diagram).

ZONE 1 (Access) - This pair of terminals may be connected to any type of normally

closed detection device. When activated during a set condition,

a full alarm is generated. It is also possible to program the zone

as "Access" this allows the detector to be activated during entry

and exit when setting/unsetting the system. If the zone is

programmed as "Access" and is armed during a part-set (Home)

condition it will start the entry timer if activated. The tamper loop

should be connected in series with other loops across the

terminals mark AUX TAMPER (see Connection Diagram).

ZONE 2 (Access) - As Zone 1.

ZONE 3 (K'SWITCH) - This pair of terminals may be connected to any type of normally

closed detection device. When activated during a set condition,

a full alarm is generated. It is also possible to program the zone

as "Keyswitch" this allows the zone to be connected to an

electrical keyswitch to set and unset the system. The keyswitch

functionality maybe further programmed to either full set (Away)

or part-set (Home) the system. (see Programming). The tamper

loop should be connected in series with other loops across the

terminals mark AUX TAMPER (see Connection Diagram).

ZONE 4 (Fire) - This pair of terminals may be connected to any type of normally

closed detection device. When activated during a set condition,

a full alarm is generated. It is also possible to program the zone

as "Fire" this allows the zone to be connected to any type of

normally closed smoke or heat detector. The tamper loop should

be connected in series with other loops across the terminals mark

AUX TAMPER (see Connection Diagram).

System Installation TSD402 Installation Manual

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Pas de commentaire

Menvier Security TS400 Manuel d'instructions Page 14