Menvier Security TS400 Manuel d'instructions télécharger pdf (Page 27)

Remote Reset Number (Cont.)

The "Remote Reset" code is generated using an algorithm identified by a 3 digit number.

Alternative algorithms may be selected but these must correspond to that used by the

alarm company otherwise the "Remote Reset" code will be incorrect.

The "Remote Reset" feature may be disabled altogether by setting the number to "000"

1 Ensure that the "ENGR. OPTION -" is displayed. Press

to select the Remote Reset

Number option.

2 Enter the Remote Reset Number using the number keys e.g., to set the number to

000 (disable Remote Reset) , enter "000"

3 When completed, press

[

to accept, a two tone acceptance tone will be heard.

System Options (key

)

The TSD402 has six system options which change the functionalityof the system. The options

are as follows:

Bell Output Type SAB (A)

When programmed as SAB the output will switch to 0V on alarm.

SCB (C) When programmed as SCB the output provides a 0V

hold off, which is removed on alarm.

Setting Mode Timed Exit (T)

The system will set when the Exit timer has expired.

Final Exit (F)

The system will set when the last detector or door contact is

activated during the exit procedure.

Note: When the system is part-set (HOME) the system will always

set by Timed Exit and is Silent.

Reset Authority User Reset (U)

Following an alarm the system can be reset by the user.

Engineer Reset (E)

Following an alarm the system can only be reset by the engineer

or Remote Reset (If enabled).

TSD402 Installation Manual Programming

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Menvier Security TS400 Manuel d'instructions Page 27