Menvier Security TS400 Manuel d'instructions télécharger pdf (Page 9)

External Sounder

The External Sounder should be mounted as high as possible so that it is visible and out of

reach to potential intruders. A six core cable is required for connection to the sounder, it

should enter directly through the wall and into the sounder via the cable entries in the back

plate. However, if the cable is run over the surface to the sounder then it should be

protected (e.g., the cable may be run in aluminium conduit).

Detection devices

There are several types of detection devices available which are suitable for domestic

installations as follows:

Passive Infra-Red

(PIR)

- A movement detector which detects movement of an intruder

by the change in infra-red body heat. When fitting PIRs, refer to

the installation instructions supplied with the unit.

In general there are two types of PIR "Standard" and "Latching".

Normally the standard type is used where one detector per zone

is fitted. A six core cable is required for connection.

The latching type is used when more than one detector is fitted

to a zone, the latch facility allows the user to identify the triggered

detector by means of the indicator LED on the detector "latching"

on. If latching detectors are used an eight core cable is required

for connection.

Magnetic

Contacts

- Magnetic contacts consist of an electrical switch which is

operated by a magnet. They come in two varieties, the "Flush"

type is designed to be fitted into the top or side of the

door/window. The "Surface" type is designed to fitted to

doors/windows where it is not possible to use flush contacts e.g.

garage doors, UPVC windows etc. Both types of contacts require

a four core cable for connections.

Personal Attack

(PA) Button

- Normally PA buttons are located by the front door or adjacent to

the bed, and preferably out of reach to small children. Pressing the

button at any time will generate a full alarm. After pressing the

button, it must be reset with the key provided and then reset at the

control panel. PA buttons require a four core cable for connections.

Vibration Detectors - Vibration detectors are normally fitted to windows or door frames.

They are triggered when the device senses a shock attack.

Vibration detectors require a six core cable for connections.

Smoke/Heat

Detectors

- 12V Smoke or heat detectors may be connected to the system

to provide additional protection against fire. When activated a

distinctive internal sounder tone is generated and the external

sounder is pulsed. Smoke detectors require a four core cable for

connections.

TSD402 Installation Manual System Planning

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Menvier Security TS400 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Menvier Security TS400