Menvier Security TS400 Manuel d'instructions télécharger pdf (Page 21)

Initial Power-Up (Cont.)

2 Switch on the 240V mains supply and remove the screwdriver blade. The internal

alarm will bleep every 30 seconds the display will show: CF-T.

3 Connect the standby battery. If the display shows: BATT. FLT and the internal

alarm sounds, then the battery may have been incorrectly connected or its voltage

is below 8V. Disconnect the battery immediately and reconnect or replace as

appropriate.

4 Push the battery into place at the bottom of the housing and re-fit the front cover.

5 The display will show: PLEASE RE-RECORD, this message will only be cleared

when one or more of the speech dialler messages has been recorded (see User

Manual for full details).

6 Enter the engineer's passcode (default

1 2 3 4

), the display will show:

ENGR. OPTION- (engineer programming menu selected)

7 The telephone lead can now be plugged into the telephone socket.

8 Fit the battery link in the external siren and replace cover.

9 The system is now ready for engineer programming.

TSD402 Installation Manual System Installation

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Pas de commentaire

Menvier Security TS400 Manuel d'instructions Page 21