Menvier Security TS400 Manuel d'instructions télécharger pdf (Page 20)

Pre Power-Up Checks

Before applying any power to the system, give the system one final check to ensure that:

1 The telephone lead is unplugged from the telephone socket.

2 The wiring and connections conforms to the requirements detailed in this manual.

3 All system cables are kept clear of mains supply cables, telephone cables and R.F.

cables. It is recommended that cable ties be used to keep cables separated.

4 Calculate the total system power consumption and ensure that it does not exceed 750mA.

5 Mains supply cables to the system are connected to an un-switched fused spur.

Initial Power-Up

1 Place a small screwdriver blade between the pins on the Control Panel PCB, marked

FACTORY RESTART (located top left corner). This will ensure that the factory default

values are loaded into memory as show below:

Engineer's Passcode - 1 2 3 4

User 1 Passcode - 5 6 7 8

User 2 Passcode - Not programmed

Zone 1 - Night

Zone 2 - Access

Zone 3 - Night

Zone 4 - Night

Zone 5 - Night

Final Exit - Exit

Exit Time - 030 Seconds

Entry Time - 030 Seconds

Bell Duration - 020 Minutes

Remote Reset Number - 004

Bell Output - SAB (-ve Applied)

Setting Mode - Timed Exit

Reset Authority - User Reset

Number of Re-arms - 3

Operation of Key Switch - AWAY Set (Full)

Operation of RST- Output - Switched 12V

Operation of Final Exit in P/Set - Final Exit

HOME Setting - Zone 1 Omitted

Dialler Alarm Options - No Alarms Report

Acknowledgement Option - Cleared by any 1

System Installation TSD402 Installation Manual

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Menvier Security TS400 Manuel d'instructions Page 20